Zadania wzorowane na pytaniach z tego arkusza: te same umiejętności, format i punktacja, inne dane i kontekst. Treści arkusza IB nie publikujemy.
W bazie 10 zadań z tego arkusza, razem 35 punktów, każde z kluczem i schematem punktowania. Najwięcej zadań sprawdza: Experimental techniques and apparatus (4), Molar concentration of solutions (3), Concluding and evaluating (3).
Rozwiąż arkuszCały arkusz po kolei. Wynik na końcu.
Dodaj cały arkusz do zestawuBefore use, the EDTA solution was standardized against a standard solution of Cu2+ ions. An accurately weighed piece of pure copper wire was dissolved in the minimum volume of concentrated nitric acid and the mixture was warmed gently until no more…
Anhydrous copper(II) chloride, CuCl2, takes up water vapour from the air, so it cannot be weighed out accurately to make a standard solution. Suggest a laboratory procedure that would remove all of the absorbed water from a sample of solid CuCl2…
Portions of the rinse water were then titrated with the standardized EDTA solution in the presence of murexide as indicator. The burette readings are given in the table. (i) Suggest two reasons why trial 1 required a much larger volume of EDTA than the other…
For the AAS method, a series of standards of known concentration was prepared by diluting a stock solution of Cu2+ ions. The instrument was zeroed with deionized water and the absorbance of each standard was recorded. (i) Draw the line of best fit for…
(i) State the independent variable and the dependent variable of the investigation. (ii) Apart from the mass of leaves and the volume of water, suggest two other conditions that should be kept constant for the comparison between boiling times to be valid.…
(i) State what the graph shows about the relationship between the boiling time and the amount of oxalate ions extracted. (ii) Comment on the range of boiling times and on the number of measurements made in the investigation.
The hypothesis being tested was that a longer boiling time would extract more oxalate ions from the leaves. (i) Evaluate the hypothesis in the light of the results, giving a reason. (ii) Suggest one way in which the investigation could be changed so that it…
Determine, using a suitable construction drawn on the graph, the initial rate at which CO2(g) is released, in g s−1, in the reaction with 1.20 mol dm−3 HNO3(aq).
For the runs with 0.40 and 0.80 mol dm−3 HNO3(aq), suggest which reactant, CaCO3(s) or HNO3(aq), was the limiting reagent. Give a reason for your answer.
If the reaction with 0.80 mol dm−3 HNO3(aq) went to completion, the theoretical mass of CO2(g) released would be 1.76 g. (i) Use the graph to determine the mass, in g, of CO2(g) actually released in this reaction. (ii)…
Zapisujemy na Twoim urządzeniu to, bez czego serwis nie działa, np. zalogowanie. Plików analitycznych użyjemy tylko za Twoją zgodą. Szczegóły w polityce prywatności.