Zadania z chemii IB SL

Anhydrous copper(II) chloride, $\ce{CuCl2}$, takes up water vapour from the air, so it cannot be weighed out accurately to make a standard solution. Suggest a laboratory procedure that would remove all of the absorbed water from a sample of solid $\ce{CuCl2}$…

Portions of the rinse water were then titrated with the standardized EDTA solution in the presence of murexide as indicator. The burette readings are given in the table. Trial 1 Trial 2 Trial 3 Trial 4 Final burette reading / $\mathrm{cm^3}$ (± 0.05…

For the AAS method, a series of standards of known concentration was prepared by diluting a stock solution of $\ce{Cu^2+}$ ions. The instrument was zeroed with deionized water and the absorbance of each standard was recorded. (i) Draw the line of best fit for…

(i) Suggest, giving a reason for each, two different safety precautions that should be taken when carrying out either of these preparations. (ii) Deduce the coefficients needed to balance the following equation for the reaction of silver with concentrated…

The amount of $\ce{NO2}$ prepared was checked by titration. The gas was first absorbed in water: $\ce{2NO2(g) + H2O(l) -> HNO3(aq) + HNO2(aq)}$ The resulting solution was made up to 200.0 $\mathrm{cm^3}$ in a volumetric flask, and 20.0 $\mathrm{cm^3}$ portions…

Suggest a sequence of experimental steps that would give a pure sample of each of the three components.

The student recorded the following masses. Sample Mass / g (± 0.01 g) Percentage by mass Mixture before separation 6.35 not applicable Iron after separation 2.58 Calcium carbonate after separation 1.71 Potassium chloride after separation 2.31 36.4 % Calculate…

Describe how a standard aqueous solution of potassium manganate(VII) can be prepared from the solid.

Describe the steps by which this standard solution is turned into a calibration curve for the colorimeter.